BREWART BREWFLO - Cleaning

BREWFLO INSTRUCTIONS
15
 Note
Remember to sanitise your
keg cap before each use.
 Note
The same beer line can be
used with the new keg.
Once a beer line is used we
recommend that it be disposed of
and replaced with a new beer line
within three days of initial use if
not kept cool within the BrewFlo
or seven days if is kept cool.
For more FAQs and information
on beer lines and storing partially
used kegs, please go to
brewart.com/101
Cleaning
Clean your BrewFlo with a clean so
damp cloth, do not use solvents or
abrasive agents, if necessary you
may use a mild detergent.
 Note
Cleaning up spills and splashes
as soon as they occur helps keep
your BrewFlo looking it's best.
During use, empty and rinse the
drip tray regularly.
When finished using the BrewFlo:
k Power o the unit at the rear switch.
k Remove the Keg and Beer Line.
k Rinse the inside of the beer
font spout with clean water.
k Drain any condensation and
spills from the inside of the unit
by pressing the drain button.
k Wipe the inside of the BeerFlo
with a so clean damp cloth.
k Empty the drip tray and
rinse it with clean water.
k Wipe the outside of the unit
with a so clean damp cloth.
k Keep empty Kegs clean and dry
and rinse and clean the Cap
assembly with clean water and
allow to air dry aer Keg is empty.