16
Power down
k Turn your BrewFlo to standby
using the button on the control
panel, or if you are not going to
use it for an extended period turn
it o completely at the power
switch at the rear of your BrewFlo.
Condensation
k Aer extended use, the
cooling chamber may fill with
condensation. If this happens,
press the drain button at the
front of your BrewFlo until all the
condensed water drains into the
tray. Any remaining condensation
in the chamber can be removed by
wiping it with a clean so cloth.
k In humid locations condensation
may appear on the bench
underneath the BrewFlo. Wipe
any condensation from the
bench with a so cloth.
WARNING
DO NOT tilt or lay your BrewFlo
on its back or side as this may
damage the compressor.
Troubleshooting
Beer pouring flat or heady?
for these and many other
troubleshooting tips, FAQs
and instructional videos,
please visit brewart.com/101
Re-setting the keg
level indicator
1. If you notice that the keg gauge
is not displaying the correct
keg levels, you may need to
re-set the load monitor.
2. Plug the power cord in and switch
your BrewArt BrewFlo on.
3. Use the button to set your
BrewFlo to standby mode
(Power is on but LCD is o).
4. Place an empty keg plus the cap
and collar in your BrewFlo (no need
to connect air and beer lines).
5. Hold
and
arrows
simultaneously for approximately 3
seconds, until your BrewFlo beeps.
6. The load monitor will be re-set
to empty, taking into account the
weight of the empty keg and cap.
Note
You don’t need to place a keg
liner in your BrewFlo as its
weight is negligible.
To Next Page
Loading...