Brink Innosource Sonair - Operating Your Sonair; Manual Ventilation Settings; Automatic Ventilation Modes

20
3.1 Ventilation using manual operation
You can set the ventilation rate of your Sonair manually using the two operating
buttons at the top of the unit. By pushing the right button you can increase the
fan speed. By pushing the left button you can decrease the fan speed and stop
the motor. The ventilation rate is variable from 0 to 225 m
3
/h. The ventilation
rates for one and two persons are marked on the display.
The ventilation rate depends on the filter type and the diameter of the duct.
The markings are based on the standard version of the Sonair, which has a
G2 filter and a duct with an inner diameter of 100 mm. The table below shows
how many cubic metres of air per hour are supplied for each type of filter and
diameter of the duct at every position of the indicator bar.
3.2 Ventilation using automatic operation
(Sonair A
+
ACC and F
+
ACC only)
If your Sonair is part of the Air Comfort Control (ACC) ventilation system, you
should set your Sonair to automatic ventilation by pushing the left operating
button until the ACC icon is shown in the display. Your Sonair ventilates
according to the ventilation programme that is controlled by the ACC's central
control panel. To switch over to manual operation, push the right button once
to activate manual operation so that the ACC icon disappears from the
display. When the ACC icon is no longer shown, you can operate the your
Sonair manually.
3
USING YOUR SONAIR
= ventilation rate for 1 person
= ventilation rate for 2 persons
= maximum ventilation rate
Diameter duct:
100 mm
225162140120105907560453026G2-Filter
-1161008371615038281715F6-Filter
-167147124108927762483329G2-Filter
-1201038673625140302018F6-Filter
Diameter duct:
120 mm
MAX
MAX
NL
EN
DE