3
2.0 Quick Start Guide
The quick start procedure, as outlined below, allows you to begin using
your system before you learn all the details of system operation.
1. Activate the Brivis Touch Controller by touching anywhere
on the LCD screen.
2. Select the required mode by pressing the “MODE” button
(where more than one option is available – i.e. HEAT, COOL
or EVAP).
3. Turn on the system by pressing the “ON/OFF” button.
4. Select the desired temperature / comfort level by using the
“UP/DOWN” buttons.
5. System will run at desired comfort level until turned OFF by
pressing the “ON/OFF” button.
You may access User Preferences and other advanced options by
pressing the “MENU” button.
3.0 Fan Operation
FAN ONLY
With the system OFF (standby) push the “FAN” button in the top right
hand corner to turn the fan ON.
If in ‘HEAT’ or ‘COOL’ mode the heater fan will turn on.
If in ‘EVAP’ mode the evaporative cooler fan will turn on.
CIRCULATION FAN
When enabled by the installer, the circulation fan will be on
continuously between Heating and Refrigerated Cooling cycles.
CIRC FAN will be indicated below the FAN icon.
To Next Page
Loading...
