60
12 hex 2 (0,0-F,F) Set Strobe Rate (in Frames)
00 = Full Motion
01 = Fastest Strobe
7F = Slowest Strobe
13 hex 1 (0-2) Select Freeze Mode
0 = Frame Mode
1 = Field Mode
2 = Strobe Mode
(Valid for MicroSYNC cards only) 3= 4-Field Mode
(Valid for TBC IV cards only) 4= Film Mode
14 hex 1 (0-2) Freeze Field Select
0 = Select Field 1
1 = Select Field 2
2 = Select Field 3
3 = Select Field 4 ...MicroSYNC only
4 = Select Field 5 ...MicroSYNC only
16hex 1 (0-F) Y/C Delay horizontal
0 = +570nS
8 = 0
F = -490nS
24hex 1 (0-3) Y/C Delay vertical
0 = +1 line
1 = 0
2 = -1 line
3 = -2 lines
25 hex 1 (0-1) Set Monochrome Mode
0 = Monochrome Mode Off
1 = Monochrome Mode On (Chroma OFF)
32 hex 2 (0,0-F,F) Set MicroSYNC Options BYTE #1
See Section below for MicroSYNC Configuration
33 hex 2 (0,0-F,F) Set MicroSYNC Options BYTE #2
See Section below for MicroSYNC Configuration
34 hex 1 (0-1) Set Frame freeze
0 = Select Frame 1
(Command valid for MicroSYNC only) 1 = Select Frame 2
35 hex 2 (0,0-F,F) Set TBC IV Configuration BYTE #1
See Section below for TBC IV Configuration.
36 hex 2 (0,0-F,F) Set TBC IV Configuration BYTE #2
See Section below for TBC IV Configuration.
To Next Page
Loading...