Broadcom 95xx User Guide
Broadcom
®
95xx PCIe 4.0 MegaRAID
®
and HBA Tri-Mode Storage Adapters
Table 19: LED Designations
LED Type Description
LED2 Yellow IOC over
temperature
Stays on solid to indicate that the SAS3816 IOC temperature sensor is over the temperature
threshold. When the device is in the proper temperature range, this LED is off.
LED3 Green system heartbeat Indicates that the SAS3816 IOC is operating normally.
HBA 9500-8i Adapter – Connector and LED Designations
The adapter is a 6.127 in. × 2.712 in. (155.65 mm × 68.90 mm) board. The component height on the top and bottom of the
adapter complies with the PCIe specification.
The following figure shows the connectors and LED locations on the adapter. Pin 1 on the headers and connectors is
highlighted in red in the figure.
Figure 7: Card Layout of the HBA SAS 9500-8i Tri-Mode Storage Adapter
The following table describes the headers and connectors on the adapter.
Table 20: Headers and Connectors
Connector Type Description
J2 Standard edge card connector The interface between the storage adapter and the host system.
With the PCIe interface, this connector provides power to the board and an I
2
C
interface connected to the I
2
C bus for the IPMI.
J4 Default SBR header 2-pin connector. Reserved for Broadcom use.
J8 Onboard serial UART connector 4-pin connector. Reserved for Broadcom use.
J17 Storage interface connector One SFF-8654 8-port internal connector.
Connects the adapter by cable to the storage devices.
Broadcom
95xx-MR-HBA-Tri-Mode-UG104
29
To Next Page
Loading...
Need help?
General