User Guide NetXtreme II
January 2010
Broadcom Corporation
Document ENGSRVT52-CDUM100-R Removing Drivers from Autoexec.ncf Page 147
REMOVING DRIVERS FROM AUTOEXEC.NCF
To remove the drivers from the Autoexec.ncf file, locate the load and bind command lines associated with the Broadcom
driver and remark them out by inserting the # symbol at the beginning of each command line, or by deleting the statement.
Example:
# LOAD BX2 SLOT=2 FRAME=Ethernet_802.2 NAME=BX2_1_E82
# BIND IPX BX2_1_E82 NET=FAFD3D25
# LOAD BX2 SLOT=2 FRAME=Ethernet_802.3 NAME=BX2_1_E83
# BIND IPX BX2_1_E83 NET=5A2D8D6D
# LOAD BX2 SLOT=2 FRAME=Ethernet_SNAP NAME=BX2_1_ESP
# BIND IPX BX2_1_ESP NET=477A35BD
# LOAD BX2 SLOT=2 FRAME=Ethernet_II NAME=BX2_1_EII
# BIND IPX BX2_1_EII NET=C3C8F2E4
# BIND IP BX2_1_EII ADDR=172.16.1.1 MASK=ff.ff.ff.0
NOTE: If you modify the Autoexec.ncf file, you must reboot the server before the changes take effect.
To Next Page
Loading...
Need help?
General
