NetXtreme II User Guide
January 2010
Broadcom Corporation
Page 200 Configuring Teaming Document ENGSRVT52-CDUM100-R
USING EXPERT MODE
Use Expert Mode to create a team, modify a team, add a VLAN, and configure LiveLink for a Smart Load Balance and
Failover and SLB (Auto-Fallback Disable) team. To create a team using the wizard, see Using the Broadcom Teaming
Wizard.
To set the default Teaming Mode, select Options from the Tools menu. In the Options window, click the General tab, then
select Expert Mode or Wizard Mode (the default is Wizard Mode).
Creating a Team
NOTE: Enabling Dynamic Host Configuration Protocol (DHCP) is not recommended for members of an SLB type
of team.
1. Click the Team Management button at the bottom of the BACS 3 window, or from the View menu, select Navigate, then
Team Management.
2. Click Teams at the top of the Team Management pane, or select one of the listed devices in the “Unassigned Adapters”
section.
3. From the Team menu, select Create a Team, or right-click one of the devices in the “Unassigned Adapters” section and
select Create a Team. This option is not available if there are no devices listed in the “Unassigned Adapters” sections,
which means all adapters are already assigned to teams.
To Next Page
Loading...
Need help?
General
