Broadcom NetXtreme II User Manual

NetXtreme II User Guide
January 2010
Broadcom Corporation
Page 238 Testing Network Connectivity Document ENGSRVT52-CDUM100-R
NETWARE
Ping an IP host on the network to verify connection has been established.
From the command line, type ping IP address, and then press ENTER.
The ping statistics that are displayed indicate whether or not the network connection is working.
LINUX
To verify that the Ethernet interface is up and running, run ifconfig to check the status of the Ethernet interface. It is possible
to use netstat -i to check the statistics on the Ethernet interface. See Linux Driver Software for information on
ifconfig and
netstat.
Ping an IP host on the network to verify connection has been established.
From the command line, type ping IP address, and then press ENTER.
The ping statistics that are displayed indicate whether or not the network connection is working.

Broadcom NetXtreme II Specifications

General

Brand	Broadcom
Model	NetXtreme II
Category	Network Card
Language	English