6-4
Advance to Next Preset:
Action: Press the RESET button once.
Response: The CYCLE COUNT display
will change to “-1” and the presets for #1
will be displayed.
Repeat the process as described. After
the presets for #9 are displayed, pressing
the RESET button again will cause the con-
trol to return to normal operation.
PRESET PROGRAMMING METHOD 2
Set Temperature:
Action: Press Cook Temperature But-
ton twice within 5 seconds.
Response: Programming mode has
been entered. Flashing Temp Display reads
“###F.” (### = temperature value ie: 360F)
Action: If desired, press keypad num-
bers to change displayed value then press
Cook Temperature Button once to enter
new value into memory.
Response: Controller returns to idle
mode.
Set Time:
Action: Press Cook Time Button twice
within 5 seconds.
Response: Programming mode has
been entered. Flashing Time Display reads
“##:##.” (##:## = time value ie: 08:00)
Action: If desired, press key pad num-
bers to change displayed value in minutes
and seconds then press Cook Time Button
once to enter new value into memory.
Response: Controller returns to idle mo
de.
When Temperature and Time have been set
press and hold the desired preset number
button until you hear a beep. The temp and
time for that preset button is saved.
Repeat these steps for the remaining preset
buttons.
boraster.com Manual #16421 5/06 Rev 6/14
To Next Page
Loading...
