6-3
Reset Cycle Counter:
Action: Press Reset Button twice in 5
seconds.
Response: Display will return to a set-
ting of “00.”
If counter is not reset
before reaching “99.”
Upon the next cycle completion, the dis-
play will begin counting at “01.”
Normal operating programming can be
done at any time without affecting presets.
PRESET COOK MODE
Choose Preset Cook Cycle:
Action: Press a button, 0 thru 9, corre-
sponding to the desired preset.
Response: The TIME display will show
“P__X”, where X is the preset selected.
If a button is not pressed
in ten seconds, the dis-
play will revert to the previous display.
Action: Press the same button again,
Response: The TIME display will show
the preset time, the TEMP display will show
the preset setpoint, and the temperature
will now regulate to the new setpoint.
PROGRAMMING PROCEDURE (PRESET
MODE)
There are 2 methods for
programming the pre-
sets. Method 1 for all VF models manu-
factured before September 1, 2012 and
method 1 or 2 for all VF models manufac-
tured after September 1, 2012.
PRESET PROGRAMMING METHOD 1
Action: Press and hold the TIME and
TEMP buttons simultaneously for three sec-
onds.
Response: The TIME display and
TEMP display will begin flashing. The
CYCLE COUNT display will show “-0” indi-
cating that the preset #0 values are dis-
played. The preset values for the TIME and
TEMP will be shown on the display.
Change Cook Time:
Action: Press the TIME button once.
Response: The TEMP display will turn
off and only the TIME display will flash.
Action: Key in the desired cook time
then press the TIME button to save the new
setting.
If a button is not pressed
in ten seconds, the dis-
play will revert back to both the TIME
and TEMP displays flashing.
Change Cook Temperature:
Action: Press the TEMP button once.
Response: The TIME display will turn
off and the TEMP display will be flashing.
Action: Key in the desired temperature
setting then press the TEMP button to save
the new setting.
Note: If a button is not
pressed in ten seconds,
the display will revert back to both the
TIME and TEMP displays flashing.
boraster.com Manual #16421 5/06 Rev 6/14
To Next Page
Loading...
