How to fix HEATER FAULT on Broaster Commercial Food Equipment?
If the Broaster Commercial Food Equipment displays a HEATER FAULT message, it indicates that the oil temperature is not rising correctly. First, verify that the gas line is properly connected. Then, check that the manual shutoff valve is open.
What to do if the Broaster Commercial Food Equipment display doesn't respond when touched?
If the Broaster Commercial Food Equipment display doesn't respond when touched, it means the screen isn't calibrated. To fix this, turn off the unit, place your finger on the screen and hold it while turning the unit back on. Touch the small box in the upper left corner until it moves to the upper right corner, then touch it again until it moves to the lower left corner, then touch it again until it disappears. The controller will then reboot.
What to do if the Broaster Commercial Food Equipment display is blank?
If the Broaster Commercial Food Equipment display is blank, it could be due to the unit being unplugged or the Hi Limit being tripped. Plug in the equipment and monitor the cycle power. If the problem repeats, call for service.
General| Power Source | Electric |
|---|---|
| Temperature Control | Thermostatic |
| Construction | Stainless Steel |
| Category | Fryer |
| Capacity | 24 lb |
| Voltage | 208-240V |
To Next Page
