EasyManua.ls Logo

Broaster E 24 Series - Cleaning Cooking Well

Default Icon
54 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9 - CLEANING
9-1
DO NOT heat or boil
water in a pressure fryer.
Disconnect main power supply. Keep
cover and pressure regulating valve
OPEN when cooking well contains water.
If cover is CLOSED on a well holding hot
or boiling water, a large quantity of
scalding water could spray out when
cover is opened causing serious burns.
Broaster
®
cooking well
cleaner is an irritant.
DO
NOT
take internally. Prolonged skin con-
tact may cause irritation and dryness.
Direct eye contact can cause irritation,
redness and temporary blurred vision.
Ingestion could cause nausea, diarrhea,
mucosal and gastric irritation. See first
aid instructions on container.
When cleaning with
water, use Broaster
®
cooking well cleaner #99500. DO NOT
use soaps and detergents. Cooking well
cleaner removes unwanted contami-
nants while also neutralizing harmful
acids. These acids, if not removed, may
damage cooking well and filter system.
To ensure cover remains OPEN when
cleaning, install cleaning flag #12814
over latch column. Cleaning flag is sup-
plied with each new unit and in cooking
well cleaner. Additional cleaning flags
can be ordered.
COOKING WELL
1. Navigate to the manual filtering screen
in the control panel or to the Discard
Used Oil screen if equiped.
2. Remove filter pan from under unit.
3. Drain and discard used oil into a suit-
able container by selecting the Open
Drain Valve button.
4. Open cover and raise fully. Install
cleaning flag #12814 over latch col-
umn.
Quarterly cleaning of
Probe Guard should be
done at this point. See PROBE GUARD
CLEANING on page 9-4.
5. Close drain valve. Fill a separate con-
tainer with 2 gallons of hot water and
thoroughly dissolve 2 cups Broaster
®
cooking well cleaner (use 93624 -
BROASTER WELL CLEANER CUP to
measure proper amount) in hot water.
Add to cooking well then finish filling
well to 1” below pressure release port.
6. Soak with cover OPEN for a minimum
of 15 minutes. Alternate method: soak
overnight up to 12 hours.
CLEANING IN PROCESS
BELOIT, WISCONSIN 53511
THE BROASTER COMPANY
DO NOT CLOSE COVER
TO USE:
CLEANING FLAG
DISCONNECT
POWER
PLACE OVER
LATCH
COLUMN
12814
broaster.com Manual #21469 621 Rev 11/23

Related product manuals