9-2
7. Drain and discard cleaning mixture.
Place pail back under drain valve, con-
nect main power supply and turn on
pump for 10 seconds to purge the filter
lines.
8. Clean cooking well using a non-metal-
lic heavy duty commercial scouring
pad that is USDA approved.
9. Rinse cleaning utensils and cooking
well with water. Turn pump on again
for 10 seconds to purge the filter lines.
Drain and discard rinse water.
10. Close drain valve. Wipe inside of cook-
ing well dry before filling with new oil.
FOOD BASKETS and SHELVES
Clean the food baskets and shelves daily.
DO NOT put food baskets and shelves in a
dishwasher. Use warm water and a low
suds organic household dish cleanser.
Rinse with vinegar and water solution (1/2
cup vinegar per gallon of water). Rinse with
clear water and completely dry before
returning to oil.
UNIT SURFACES
Frequently wipe off excess oil and crumbs
with a clean cloth or paper towel. DO NOT
use harsh abrasives and chemicals.
Rags or papers contain-
ing cooking oil can catch
fire if exposed to heat. Laundering will
not remove the oil. Dispose of all oil-
soiled papers and rags in a trash con-
tainer that is in a ventilated area away
from all cooking equipment or other heat
sources such as direct sunlight.
CONDENSATE PAN
Check liquid level several times daily.
Empty as needed.
Water and HOT OIL DO
NOT
mix. DO NOT pour
contents into cooking well or filter pan.
HOT OIL could splash causing serious
burns.
COVER
Keep a spare O-ring on
hand in case of accidental
damage.
1. Raise cover to the fully open position.
2. Rotate cover handle to CLOSED posi-
tion. Using O-ring tool #12791 or a
small dull tool such as a spoon handle,
remove cover O-ring.
4. Clean O-ring using warm water only.
DO NOT use detergents. Hold wet rag
around O-ring and pull through several
times.
5. Clean O-ring groove and cover top
and bottom. Use O-ring tool #12791 to
clean O-ring groove. Use a non-metal-
lic heavy duty commercial scouring
pad that is USDA approved to clean
cover.
6. Remove any oil or grease build-up
from Pressure Relief Valve port on bot-
tom of cover.
7. After cleaning, completely dry. Lubri-
cate O-ring with clean liquid shorten-
ing. Install O-ring in O-ring groove.
broaster.com Manual #21469 621 Rev 11/23
To Next Page
Loading...
