To Next PageTo Next PageHow to resolve an overtravel error on a Brother BE-1204B Sewing Machine?
To resolve an overtravel error on your Brother Sewing Machine, check if the frame is within the cap frame area and verify the signal of the X area sensor in PORT test mode.
Why does the upper shaft lock on my Brother BE-1204B Sewing Machine?
If the upper shaft locks at a certain point in one cycle on your Brother Sewing Machine, check if the thread take-up is stopped due to interference with the thread take-up cover and verify if the needle bar clamp and the top dead center stopper are positioned correctly.
What does 'Release stop SW to operate!' mean on my Brother BE-1204B?
If your Brother Sewing Machine displays the message "Release stop SW to operate!", it indicates that you should check if the stop switch is turned on.
Why is the needle hitting the embroidery hoop on my Brother BE-1204B?
If the needle or presser foot is interfering with the embroidery hoop on your Brother Sewing Machine, check if the embroidery hoop is too small and verify the size and needle start position in the sewing data.
How to fix embroidery issues on my Brother BE-1204B Sewing Machine?
If your Brother Sewing Machine is not embroidering properly, check if the material edge is caught in the machine, ensure the material is stretched properly, verify the thread tension is proper, and check if the lower thread comes out smoothly.
Why my Brother Sewing Machine cannot make stitches?
If your Brother Sewing Machine is not creating stitches, check if the needle is attached properly and ensure the timing of the needle and rotary hook is correct.
What to do if my Brother Sewing Machine doesn't turn on?
If your Brother Sewing Machine does not operate even when powered on, check the following: * Ensure the power cord is properly plugged in. * Verify the connector at the side of the control box is connected. * Check the connector inside the control box. * Inspect the fuse on the PCB in the control box for any signs of being blown.
General| Type | Embroidery Machine |
|---|---|
| Number of Heads | 1 |
| LCD Display | Yes |
| USB Connectivity | Yes |
| Needle Threader | Yes |
| Free Arm | Yes |
