5 - 15 TROUBLESHOOTING AND ROUTINE MAINTENANCE
Packing and shipping the DCP
Whenever you transport the DCP, use the packing materials that
came with your DCP. If you do not pack the DCP properly, you could
void your warranty.
Caution
It is important to allow the DCP to ‘park’ the print head after a print
job. Listen carefully to the DCP before disconnecting it from the
power source to ensure that all mechanical noise has stopped. Not
allowing the DCP to complete this parking process may lead to print
problems and possible damage to the print head.
1
Lift the scanner cover from the right-hand side of the DCP until
it locks securely into the open position.
2
Remove all the ink cartridges and attach the protective parts.
(See Replacing the ink cartridges on page 5-20.)
Caution
If you are not able to find the protective parts, do NOT remove the ink
cartridges before shipping. It is essential that the DCP be shipped
with either the protective parts or the ink cartridges in position.
Shipping without them will cause damage to your DCP and may void
your warranty.
When attaching the protective parts,
make sure it clips into place as shown in the diagram.
Downloaded from ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
