Brother DCP-7055 - Inputting the Adjusted Value of the Laser Unit

4-4 Confidential
1.5 Inputting the Adjusted Value of the Laser Unit
(1) Select Input Information from Menu.
(2) Select the applicable model name.
(3) Select “Adjust Scanner” from Menu.
(4) Check the port (USB) that the machine is connected through.
(5) Enter the figures (the last four digits) shown on the laser serial label attached on the
figure below. (Refer to Fig. 4-1 .)
(6) Click the OK button.
Fig. 4-1
Laser plate
Laser unit
Laser serial label