5-29
Confidential
1.4.20
Setting by country (Function code 74)
<Function>
This function allows you to customize the machine according to language, function settings,
and worker switch settings.
<Operating Procedure>
(1) Press the 7 and 4 buttons in this order in the initial state of the maintenance mode.
In the case of the model without the numeric keys; Press the or button. The
“MAINTENANCE 74” appears on the LCD. Then press the OK button.
The present country code is displayed.
(2) Enter the desired country code (e.g., MFC-7860DW (U.S.A): 0201).
In the case of the model without the numeric keys; Press the or button several
times. The desired number appears on the LCD. Then repeat this operation for each
number.
The newly entered code appears.
(3) Press the OK button. In the case of the model without the numeric keys; Press the Start
button. The machine saves the setting and displays the “PARAMETER INIT” on the
LCD. The machine beeps for one second and returns to the initial state of the
maintenance mode.
Note:
• When you replace the main PCB ASSY and rewrite the firmware forcibly, be sure to
carry out this procedure.
Note:
• The machine does not work properly when an incorrect code is entered.
Memo:
• When the Stop/Exit button is pressed, or when no button is pressed for one second
procedure during the above procedure, the machine cancels the above, beeps for one
second and returns to the initial state of the maintenance mode. In this case, the
modified setting data is not saved.
To Next Page
Loading...
