Changing your machine’s network settings
5
2
c Double-click the unconfigured device.
• If the print server is set to its factory default settings (if you are not using a DHCP/BOOTP/RARP server),
the device will appear as Unconfigured in the BRAdmin Light utility screen.
• You can find the Node Name and MAC Address (Ethernet Address) by printing the Network Configuration
List. (See Printing the Network Configuration List on page 36 for information on how to print the Network
Configuration List on your print server.) You can also find the Node Name and MAC Address from the
control panel. (See Chapter 5: Control panel setup.)
d Choose STATIC from Boot Method. Enter the IP Address, Subnet Mask and Gateway (if needed) of
your print server.
e Click OK.
f With the correctly programmed IP address, you will see the Brother print server in the device list.
Windows
®
Macintosh
Windows
®
Macintosh
To Next Page
Loading...
Need help?
General
