Loading paper and documents
11
2
b <For printing envelopes only>
Pull down the two blue levers, one on
the left-hand side and one on the right-
hand side, toward you as shown in the
illustration below.
c Open the MP tray and lower it gently.
d Pull out the MP tray support (1) and
unfold the flap (2).
e While pressing the paper side guide
release lever, slide the paper guides to
fit the width of the paper that you are
going to use.
IMPORTANT
Make sure the paper guides touch the
sides of the paper so it will feed properly.
f Put the envelopes (up to 3), thick paper,
labels or transparencies in the MP tray
with the top edge first and the print side
face up. Make sure that the paper stays
under the maximum paper mark (b).
2
1
To Next Page
Loading...
