How to scan to a computer
35
Changing the SCAN key settings 7
Before scanning 7
To use the machine as a scanner, install a scanner driver. If the machine is on a network,
configure it with a TCP/IP address.
Install the scanner drivers from the Installer CD-ROM. (uu Quick Setup Guide)
(for DCP-8110DN and DCP-8155DN)
Configure the machine with a TCP/IP address if network scanning does not work.
(uu Software User's Guide: Configuring Network Scanning (Windows
®
))
SCAN key settings 7
You can change your machine’s SCAN key settings using ControlCenter4.
a Open ControlCenter4 by clicking Start/All Programs/Brother/XXX-XXXX (where
XXX-XXXX is your model name)/ControlCenter4. The ControlCenter4 application will open.
b Make sure the machine you want to use is selected from the Model pull-down list.
c Click the Device Settings tab.
d Click Device Scan Settings.
To Next Page
Loading...
