Brother DCP-J4110DW - Checking the Print Alignment

52
NOTE
When a print head nozzle is clogged, the
printed sample looks like this.
A4, Letter and Executive
A3, Ledger, Legal, A5, A6, envelopes,
Photo (10  15 cm), Photo L
(89  127 mm), Photo 2L (13  18 cm)
and Index Card (127  203 mm)
After the print head nozzle is cleaned, the
horizontal lines are gone.
Checking the print alignment A
If your printed text becomes blurred or
images become faded, you may need to
adjust the print alignment after transporting
the machine.
a Press (Settings).
NOTE
If is on the Touchscreen, you can
press it, and then go to step e.
b Press s or t on the Touchpanel to
display General Setup.
c Press General Setup.
d Press Ink.
e Press Test Print.
f Press Alignment.
g Press Start.
The machine starts printing the
Alignment Check Sheet.
h For the “A” pattern, press the number of
the test print that has the least visible
vertical stripes (1-9).
i For the “B” pattern, press the number of
the test print that has the least visible
vertical stripes (1-9).
j For the “C” pattern, press the number of
the test print that has the least visible
vertical stripes (1-9).
k For the “D” pattern, press the number of
the test print that has the least visible
vertical stripes (1-9).
l Press .