Brother DCP-J4110DW - Machine Information; Checking the Serial Number; Reset Functions; How to Reset the Machine

Troubleshooting
75
B
Machine Information B
Checking the serial number B
You can see the machine’s serial number on
the Touchscreen.
a Press (Settings).
b Press s or t on the Touchpanel to
display Machine Info.
c Press Machine Info.
d Press Serial No.
e Press .
Reset functions B
The following reset functions are available:
1 Network
You can reset the print server back to its
default factory settings, such as the
password and IP address information.
2 All Settings
You can restore all settings to their factory
defaults.
Brother strongly recommends performing
this procedure before handing over or
disposing of the machine.
NOTE
Unplug the interface cable before you
choose Network or All Settings.
How to reset the machine B
a Press (Settings).
b Press s or t on the Touchpanel to
display Initial Setup.
c Press Initial Setup.
d Press s or t to display Reset.
e Press Reset.
f Press Network or All Settings.
g Press Yes to confirm.
h Press Yes for 2 seconds to reboot the
machine.