Brother DCP375CW - Control Panel ASSY

6-27
Confidential
6.1.5 Control Panel ASSY
*1 For models with color LCD
*2 For models with touch panel
(1) Remove three screws from the control panel ASSY.
(2) Pull up the rear end of the control panel ASSY and turn it up slightly.
NOTE: Do not pull the control panel ASSY away from the machine since it is connected to
the machine with a short LCD flat cable
*1
and harnesse(s).
(3) While holding the control panel ASSY at an angle of approx. 45°, disconnect the panel-
main harness, touch panel harness
*2
, grounding wire
*2
, and LCD flat cable
*1
from the
main PCB.
NOTE:
After disconnecting the flat cable(s), check that each cable is not damaged at its
end or short-circuited. When connecting the flat cable(s), do not insert it at an angle. After
insertion, check again that it is not at an angle.
"a": Taptite, bind B M3x10
"b": Taptite, cup S M3x6
Upper cover
Main PCB
Panel-main harness
Touch panel harness
Connector for
touch panel harness
Connector for
panel-main harness
Connector for
LCD flat cable
"a"
LCD flat cable
Control panel ASSY
(6_33)
*
2
*
1
*
1
*
2
*
2
"a"
"a"
"b"
Grounding wire
*
2