Brother DCP375CW - 2 ] Clean the New Head;Carriage Unit (Function Code 76)

7-11
Confidential
[ 2 ] Clean the new head/carriage unit (Function code 76)
(1) Open the ink cartridge cover, set new ink cartridges into the ink refill ASSY, and close the
ink cartridge cover.
(2) Carry out a purge operation (with function code 76) using the steps below. (See Chapter 9,
Section 9.4.26.)
Press the 7 and 6 keys in this order. (For models without numerical keypad, enter 7 and 6 in
this order using the , and OK keys.)
The machine displays "CLEANING ALL" on the LCD and enters the purge mode.
For the head/carriage unit having a round, blue seal*
, press the 0 and Black Start (Mono
Start) keys in this order to start the head replacement purge. (For models without
numerical keypad, enter 0 using the , and OK keys and then press the Black Start
(Mono Start) key.)
For the one having no seal
, press the 4 and Black Start (Mono Start) keys in this order to
start the initial purge. (For models without numerical keypad, enter 4 using the , and
OK keys and then press the Black Start (Mono Start) key.)
* Some spare head/carriage units have a round, blue seal on their left sides as shown below.
The machine starts a head replacement purge or an initial purge that refills the ink supply
tubes and the new print head with fresh ink.
Blue seal
(head_blue_seal_BHM9)