6-50
Confidential
6.1.10 MJ/PS Shield Unit (MJ PCB* and Power Supply PCB)
* For MFC only
(1) If the main PCB shield frame has not been removed, disconnect the power supply harness,
main-MJ (LINE) harness* and main-MJ (EXT) harness* from the main PCB, then remove
screw "d" (shown on the previous page) from the main PCB shield frame.
(2) Remove the two screws ("h" and "i") as shown below.
(3) Release the harnesses from the cable guides provided on the lower cover and remove the
MJ/PS shield unit from underside of the lower cover.
"h": Screw, pan (s/p washer) M3x8
"i": Taptite, cup S M3x6
"i"
"h"
Main-MJ (LINE) harness*
Main-MJ (EXT) harness*
Power supply harness
MJ/PS shield unit
Lower cover
(6_49)
U-shaped cutout
To Next Page
Loading...
