Brother DCP375CW - Hook Switch PCB (for Models with Handset)

6-58
Confidential
6.1.11 Hook Switch PCB (for models with handset)
(1) Make sure that the MJ/PS shield unit has been removed.
(2) Make sure that the hook switch harness has been disconnected from the main PCB.
(3) Release the hook switch actuator from the lower cover, turn it counterclockwise (viewed
from the left), and remove it together with the spring.
(4) Place the machine on its right end and support it by hand.
(5) Press the latch (the black plastic part on the lower cover) that locks the bottom of the hook
switch PCB, to release the PCB.
Hook switch PCB
(Left)
Lower cover
Spring
Hook switch
actuator
(6_53)
Latch
Lower cover
Bottom of
hook switch PCB
(6_54)