9-49
Confidential
(7) If either of the left and right margins is out of the specified range, press the 6 key twice and
the * key on the machine. For models without numerical keypad, enter 6, 6, and * in this
order using the , and OK keys.
The "LEFT: 10" appears on the LCD.
(8) To adjust the left margin in 600 dpi, enter the measured value (in units of 0.1 mm)
multiplied by 10.
In this example, the left margin measured in step (6) is 0.8 mm, so press the 0, 8, and OK
keys.
NOTE: For models having no OK key on the control panel, press the Photo Capture key.
The "RIGHT1: 10" appears on the LCD.
(9) To adjust the right margin in 600 dpi, enter the measured value (in units of 0.1 mm)
multiplied by 10.
In this example, the right margin measured in step (6) is 1.1 mm, so press the 1, 1, and OK
keys. For models without numerical keypad, enter 1 and 1 using the , and OK keys
and then press the OK key again.
The "LEFT2: 10" appears on the LCD.
(10)To adjust the left margin in 1200 dpi, enter the measured value (in units of 0.1 mm)
multiplied by 10.
In this example, the right margin measured in step (6) is 0.9 mm, so press the 0, 9, and OK
keys. For models without numerical keypad, enter 0 and 9 using the , and OK keys
and then press the OK key again.
The "RIGHT2: 10" appears on the LCD.
(11) To adjust the right margin in 1200 dpi, enter the measured value (in units of 0.1 mm)
multiplied by 10.
In this example, the right margin measured in step (6) is 1.2 mm, so press the 1, 2, and OK
keys. For models without numerical keypad, enter 1 and 2 using the , and OK keys
and then press the OK key again.
Upon completion of the entry, the machine automatically returns to the initial stage of the
maintenance mode.
(12)Go back to step (5) and print out the "MEDIA & BOTTOM CHECK" pattern again.
(13)Measure the left and right margins on the printed pattern.
If both of the left and right margins are within the range from 0.9 to 1.1 mm, the adjustment
is completed.
Bottom margin adjustment
(14)Measure the bottom margin on the printed pattern.
(Example) Bottom margin: 3.1 mm
If it is within the range from 2.9 to 3.1 mm, no adjustment is required. If not, go to step
(15).
(15)If the bottom margin is out of the specified range, press the 6 key twice and the # key on the
machine. For models without numerical keypad, enter 6, 6, and # in this order using the ,
and OK keys.
NOTE: In models with touch panel, to display the numerical, * and # keys, it is necessary
to switch the software keypad between the numerical and function keypads by pressing the
Scan and Copy keys simultaneously.
The "BOTTOM: 30" appears on the LCD.
To Next Page
Loading...
