Brother HL-5130 - Page 150

HL-5130/5140/5150D/5150DN Service Manual
4-49
(3) Remove the two bind B M4x12 Taptite screws, and then remove the inlet holder.
(4) Remove the bind B M4x12 Taptite screw, and then remove the SW holder.
(5) Remove the Fan motor 60.
(6) Remove the low-voltage PS PCB from the frame.
Fig. 4-86
NOTE: Procedures of reassembling inlet harness
(1) Assemble the inlet.
(2) Assemble the fan motor 60 LV.
(3) Pull the inlet harness backside of the fan motor 60 LV toward the SW holder to take up the
slack of the fan motor 60 backside harness. (Important!)
(4) Assemble the SW holder.
Taptite, bind B M4x12
Inlet holder
Inlet
SW holder
Taptite, bind B M4x12
Fan motor 60
Low-voltage PS PCB