Brother HL-5130 - High-Voltage Ps Pcb Assy; Low-Voltage Ps Pcb Assy

CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
4-48
3.21 High-voltage PS PCB ASSY
(1) Remove the bind B M4x12 Taptite screw, and then remove the high-voltage PS PCB
ASSY.
(2) Disconnect the flat cable from the high-voltage PS PCB ASSY.
Fig. 4-84
3.22 Low-voltage PS PCB ASSY
(1) Remove the bind B M4x12 Taptite screw.
(2) Disconnect the two connectors from the low-voltage PS PCB, and then remove the low-
voltage PS PCB.
Fig. 4-85
Main PCB/Engine
PCB Connector
Heater Connector
Taptite, bind B M4x12
Low-voltage PS PCB
Taptite, bind B M4x12
Flat cable
High-voltage PS PCB ASSY