Brother HL-5450DN - Ethernet (Wired Network Only); Wired Status; Setup Wizard (Wireless Network Only); WPS (Wi-Fi Protected Setup);Aoss (Wireless Network Only)

38
Control panel setup
4
Ethernet (wired network only) 4
Ethernet link mode. Auto allows the print server to operate in 1000BASE-T full duplex (For HL-6180DW(T)),
100BASE-TX full or half duplex, or in 10BASE-T full or half duplex mode by auto negotiation.
Note
• If you set this value incorrectly, you may not be able to communicate with your print server.
• For details about 1000BASE-T full duplex operation, see Gigabit Ethernet (wired network only) (For
HL-6180DW(T)) uu page 48.
Wired Status 4
This field displays the current wired network status.
Setup Wizard (wireless network only) 4
The Setup Wizard guides you through the wireless network configuration. (For more information:
uu Quick Setup Guide or Manual configuration from the control panel uu page 18.)
WPS (Wi-Fi Protected Setup)/AOSS™ (wireless network only) 4
If your WLAN access point/router supports either WPS (PBC
1
) or AOSS™ (Automatic Wireless mode), you
can configure the machine easily. (For more information: uu Quick Setup Guide or One push configuration
using WPS (Wi-Fi Protected Setup) or AOSS™ uu page 27.)
1
Push Button Configuration
WPS (Wi-Fi Protected Setup) w/PIN Code (wireless network only) 4
If your WLAN access point/router supports WPS (PIN Method), you can configure the machine easily. (For
more information, see Configuration using the PIN Method of WPS (Wi-Fi Protected Setup) uu page 29.)
WLAN Status (wireless network only) 4
Status 4
This field displays the current wireless network status.
Signal 4
This field displays the current wireless network signal strength.