If your LCD error message was repeat paper jam messages, for example [Repeat Jam Rear], move the
print head (if necessary) to take out any paper remaining in this area. Make sure pieces of paper are not left
in the corners of the machine (1) and (2).
When finished, continue with the next step.
IMPORTANT
• If the print head is in the right corner as shown in the illustration, you cannot move the print head.
Close the top cover, and then reconnect the power cord. Open the top cover again, and then hold
down until the print head moves to the center. Then unplug the machine from the power source
and take out the paper.
• If the paper is jammed under the print head, unplug the machine from the power source, and then
move the print head to take out the paper.
• If ink gets on your skin or clothing, immediately wash it off with soap or detergent.
8. Gently close the top cover using the finger holds on each side.
253
To Next Page
Loading...
