Chapter 2
12
e Gently put the paper into the paper tray
print side down and top edge first.
Check that the paper is flat in the tray.
f Gently adjust the paper side guides with
both hands and the paper length guide
to fit the paper.
Make sure that the paper guides touch
the edges of the paper.
Note
Be careful that you do not push the paper
in too far; it may lift at the back of the tray
and cause feed problems.
g Close the output paper tray cover (1)
and slide it forward.
h Slowly push the paper tray completely
into the machine.
i While holding the paper tray in place,
pull out the paper support (1) until it
clicks and unfold the paper support
flap (2).
Note
Do not use the paper support flap for
Legal size paper.
1
2
1
To Next Page
Loading...
Need help?
General
