Brother MFC-7290 - Back Cover

3-30
Confidential
9.4 Back cover
(1) Open the back cover.
(2) Push the both side ribs of the back cover outward, and release the two bosses of the
outer chute ASSY.
(3) Pull the back cover in the direction of arrow 3a, and remove it from the pin, and then
slide it in the direction of arrow 3b to remove it from the machine.
(4) Release the hook, and remove the back cover sensor lever from the back cover.
Fig. 3-13
Assembling Note :
• When assembling the back cover, close the back cover with engaging the two bosses
of the outer chute ASSY with the groove of both side ribs of the back cover.
Back cover sensor lever
Pin
Back cover
Back cover
Rib
Boss
Rib
Boss
Hook
3a
3b