Brother MFC-7290 - Page 193

3-69
Confidential
(4) Remove the registration earth spring from the motor drive sub ASSY and the conductive
bearing 5.
(5) Remove the conductive bearing 5 from the pin of the main frame L ASSY, and turn it to
the direction of arrow 5 until the releasing position, and then pull out the conductive
bearing 5 from the registration roller shaft 2.
(6) Pull out the registration roller shaft 2.
Fig. 3-59
Assembling Note :
• Assemble the registration earth spring as shown in the above figure.
Pin
Motor drive sub ASSY
Registration
earth spring
Registration roller shaft 2
Conductive bearing 5
Registration earth spring
5