Brother MFC-7290 - Page 272

App. 2-1
Confidential
APPENDIX 2 DELETING USER SETTING INFORMATION
In this machine, the user setting information is stored in the EEPROM and flash memory of
the main PCB ASSY. You can delete all the data listed below at a time with the procedure
given below.
• Information related to Net
• User setting information
<Operating Procedure>
(1) Press the [Menu] button while the machine is in the ready state.
(2) Press the [ ] or [ ] button to display "Initial Setup" on the LCD, and press the [OK]
button.
(3) Press the [ ] or [ ] button to display "Reset" on the LCD, and press the [OK] button.
(4) Press the [ ] or [ ] button to display "All Settings" on the LCD, and press the [OK]
button.
"1.Reset 2.Exit" appears on the LCD.
(5) Press the [1] button, and "Reboot OK? 1.Yes 2.No" appears on the LCD.
(6) Press the [1] button, and "Accepted" appears on the LCD. The user setting information is
deleted, and the machine returns to the ready state.
Note:
• The machine returns to the ready state automatically if no panel operation is
performed for 30 seconds.