2-31
Confidential
Error code 5A to 62
These errors do not usually occur in the normal use. The conceivable causes are noise
around the installation site, fluctuation of the power supply voltage, and failures in the
software.
An unidentified error occurred.
Error code 63
The number of rotations of the developer roller reached the upper limit when Stop Mode is
set for the toner cartridge.
Error code 64 to 66
These errors do not usually occur in the normal use. The conceivable causes are noise
around the installation site, fluctuation of the power supply voltage, and failures in the
software.
An unidentified error occurred.
---
<User Check>
• Turn OFF the power switch, and turn it ON again after a while.
Step Cause Remedy
1 Main PCB failure Replace the main PCB ASSY.
Replace Toner
Open the Front Cover, replace Toner Cartridge.
<User Check>
• Replace the toner cartridge with a new one.
• Press the [Menu] button. Next, press the [1] button and [7] button to clear the Stop
Mode*, and shift to the Continue Mode.
Step Cause Remedy
1 Main PCB failure Replace the main PCB ASSY.
CAUTION:
• When the machine is in the Stop Mode, LCD shows "REPLACE TONER" to guarantee the
print quality. On the other hand, when the Continue Mode is turned ON, the end user can
choose either to continue printing or replace the toner cartridge with a new one.
---
<User Check>
• Turn OFF the power switch, and turn it ON again after a while.
Step Cause Remedy
1 Main PCB failure Replace the main PCB ASSY.
To Next Page
Loading...
