Configuring your machine for a wireless network (For HL-2280DW, DCP-7070DW and MFC-7860DW)
14
3
Configuration temporarily using a USB or network cable 3
You can temporarily use a USB cable or network cable to configure your Brother machine for your wireless
network.
USB method 3
You can remotely configure the machine from a computer that is also on the network using a USB cable
(A)
1
.
1
You can configure the wireless settings of the machine using a USB cable temporarily connected to a wired or wireless computer.
Ethernet cable method 3
If there is an Ethernet Hub or Router on the same network as the WLAN access point (A), you can
temporarily connect the Hub or Router to the machine using a network cable (B). You can then remotely
configure the machine from a computer on the network.
A
B
A
To Next Page
Loading...
