Brother MFC-7360N - Page 23

Configuring your machine for a wireless network (For HL-2280DW, DCP-7070DW and MFC-7860DW)
18
3
e Press a or b to choose Setup Wizard.
Press OK.
WLAN
2.Setup Wizard
f When WLAN Enable ? is displayed, choose On.
This will start the wireless setup wizard.
To cancel, press Stop/Exit.
WLAN Enable ?
1.On 2.Off
g The machine will search for your network and display a list of available SSIDs.
Choose <New SSID> using a or b.
Press OK.
Select SSID&Set
<New SSID>
h Enter the SSID name. (For information how to enter text, see the Quick Setup Guide.)
Press OK.
SSID:
i Using a or b, choose Ad-hoc or Infrastructure when instructed.
Press OK.
Mode Select
Infrastructure
Do one of the following:
If you chose Ad-hoc, go to step k.
If you chose Infrastructure, go to step j.
j Choose the Authentication method using a or b, and press OK.
Do one of the following:
Auth. Select
Open System
If you chose Open System, go to step k.
If you chose Shared Key, go to step l.
If you chose WPA/WPA2-PSK, go to step m.
k Choose the Encryption type None or WEP using a or b, and press OK.
Do one of the following:
Encryption Type?
None
If you chose None, go to step o.
If you chose WEP, go to step l.