Setting Up the Machine
4
STEP1
1
1 Removing the protective
parts
1 Remove the protective tape and film covering
the scanner glass.
2 Remove the foam bag containing the ink
cartridges from on top of the paper tray.
Improper Setup
DO NOT connect the interface cable.
Connecting the interface cable is done during
the software installation process.
2 Connecting the cradle power
cord
1 Remove tape and plastic bag from the AC
adapter.
2 Route the AC power cord through the guide on
the side of the machine. Then, plug the adapter
into an AC power outlet.
3 Installing the battery
1 Make sure you remove the battery, battery
cover and cordless handset from the carton.
2 Unpack a battery, battery cover and cordless
handset.
3 Insert the connector (1) of the battery (2) in the
direction shown below.
1
2
To Next Page
Loading...
Need help?
General
