Setting Up the Machine
5
4 Place the battery in the position shown.
5 Install the battery cover by sliding it onto the
back of the handset.
Note
Be careful that you do not catch the battery
connector cord.
Caution
After installation, charge the battery more than
12 hours.
4 Charging the battery
1 Place the cordless handset on the cradle with
the dial pad facing forward.
Note
• After replacement, you should set the date and
time. (See Date and Time in the Digital Cordless
Handset User’s Guide.)
• The LCD of the handset will display “Seaching for
Base Unit” or “Base Unit not detected” until the
initial setup of the machine is complete.
• If your battery is getting low, you should charge the
battery. You can see the battery strength at the
bottom right of the LCD.
5 Choosing a location
Choose a location where the temperature remains
between 50° F and 95° F (10° and 35° C).
DO NOT put the cordless handset near heaters,
air conditioners, water or chemicals.
DO NOT expose the cordless handset to direct
sunlight, excessive heat, moisture, or dust.
DO NOT use the cordless handset near the
electro-medical equipment.
DO NOT put the machine (base unit) or cordless
handset near other electronic devices.
9.8 ft
(3m)
mouse
USB memory
headset
Bluetooth product
To Next Page
Loading...
Need help?
General
