Brother MFC-9330CDW - Page 19

19
Macintosh
Wired Network
Windows
®
Macintosh
Wired Network
For Macintosh Wired Network Interface Users
(Mac OS X v10.6.8, 10.7.x, 10.8.x)
14
Before you install
a Make sure your machine is connected to an AC
power source and your Macintosh is ON. You
must be logged on with Administrator rights.
b Remove the protective cap from the Ethernet
port marked with a symbol on your
machine.
c Connect the network interface cable to the
Ethernet port on your machine, and then
connect it to a free port on your hub.
d Make sure your machine is turned on.
15
Install MFL-Pro Suite
a Put the CD-ROM into your CD-ROM drive, and
then double-click the BROTHER icon on your
desktop.
b Double-click the Start Here OSX icon. If
prompted, select your model.
c Choose Wired Network Connection
(Ethernet), and then click Next.
d The installation screens appear one after
another. If prompted, follow any on-screen
instructions.
e Choose your machine from the list, and then
click Next.
IMPORTANT
For Mac OS X v10.6.7 or lower users: upgrade to
Mac OS X v10.6.8, 10.7.x, 10.8.x. (For the latest
drivers and information for the Mac OS X you are
using, visit http://solutions.brother.com/
.)
IMPORTANT
DO NOT cancel any of the screens during the
installation. It may take a few minutes for the
installation to complete.
NOTE
If your machine is not found over the network,
confirm your network settings (see Before you
install on page 19).