Chapter 2
16
e Open the back cover (Face up output
tray).
f Pull down the two gray levers, one on
the left-hand side and one on the right-
hand side, to the envelope position as
shown in the illustration below.
g Close the back cover.
h Send the print data to the machine.
i When you have finished printing, open
the back cover and reset the two gray
levers which were pulled down in step f
back to their original positions.
• Remove each printed envelope
immediately to prevent a paper jam.
• If your thick paper curls during printing, put
only one sheet at a time in the MP tray and
open the back cover (back output tray) to
let the printed pages exit to the back
output tray.
• To easily remove a small printout from the
output tray, lift up the scanner by using
both hands as shown in the illustration.
• You can still use the machine while the
scanner is up. To close the scanner, push
it down with both hands.
To Next Page
Loading...
