Brother MFC-9560CDW - Connecting the Brother Machine to the Wireless Network

25
For Wireless Network Users
Wireless Network
Windows
®
Macintosh
Connecting the Brother machine to the wireless network
20
Configure the wireless
settings using the
automatic wireless mode
a Confirm your WLAN access point/router has
the Wi-Fi Protected Setup or AOSS™ symbol
as shown below.
b Place the Brother machine within range of your
Wi-Fi Protected Setup or AOSS™ access
point/router. The range may differ depending
on your environment. Refer to the instructions
provided with your access point/router.
c On your machine, press Menu, 7 (Network),
2 (WLAN), 3 (WPS/AOSS).
When WLAN Enable ? is displayed, press a
or b to choose On and press OK. This will start
the wireless setup wizard.
Otherwise press Stop/Exit to exit from the
wireless setup wizard.
When Start WPS/AOSS on your
wireless access point/router.
appears, press the Wi-Fi Protected Setup or
AOSS™ button on your WLAN access
point/router. See the user’s guide for your
WLAN access point/router for instructions. And
then press OK.
This feature will automatically detect which
mode (Wi-Fi Protected Setup or AOSS™) your
access point/router uses to configure your
machine.
d A connection result message appears on the
LCD and a WLAN report will automatically be
printed.
If the connection failed, check the error code on
the printed report and refer to
Troubleshooting on page 27.
To install the MFL-Pro Suite, continue to
step 21.
For Windows
®
Users:
Now go to
page 31
For Macintosh Users:
Now go to
page 33
Note
If your WLAN access point/router supports Wi-Fi
Protected Setup (PIN Method) and you want to
configure your machine using the PIN (Personal
Identification Number) Method, see Using the PIN
Method of Wi-Fi Protected Setup in the Network
User's Guide.
Wireless setup is now complete. A four
level indicator at the right of your
machine’s LCD will show the wireless
signal strength of your access
point/router.