Brother MFC-J1300DW - Page 616

Level 1 Level 2 Level 3 Level 4 Descriptions
Wired LAN
(MFC-J1300DW)
TCP/IP DNS Server
- Specify the IP address of the primary or
secondary DNS server.
APIPA
- Set the machine to allocate the IP
address from the link-local address
range automatically.
IPv6
- Turn the IPv6 protocol on or off. For
more information, go to the Brother
Solutions Center at support.brother.com
to see FAQs & Troubleshooting.
Ethernet
- - Select the Ethernet link mode.
Wired Status
- - View the current wired status.
MAC Address
- - View the machine's MAC address.
WLAN TCP/IP BOOT Method
- Select the Boot method that best suits
your needs.
IP Address
- Enter the IP address.
Subnet Mask
- Enter the Subnet mask.
Gateway
- Enter the Gateway address.
Node Name
- Enter the Node name.
WINS
Configuration
- Select the WINS configuration mode.
WINS Server
- Specify the IP address of the primary or
secondary WINS server.
DNS Server
- Specify the IP address of the primary or
secondary DNS server.
APIPA
- Set the machine to allocate the IP
address from the link-local address
range automatically.
IPv6
- Turn the IPv6 protocol on or off. For
more information, go to the Brother
Solutions Center at support.brother.com
to see FAQs & Troubleshooting.
Setup Wizard
- - Configure your wireless network settings
manually.
WLAN Assistant
- - Configure your wireless network settings
using the Brother installation disc.
WPS
- - Configure your wireless network settings
using the one-button push method.
WPS w/ PIN
Code
- - Configure your wireless network settings
using WPS with a PIN.
WLAN Status Status
- View the current wireless network
status.
Signal
- View the current wireless network signal
strength.
SSID
- View the current SSID.
Comm. Mode
- View the current Communication mode.
MAC Address
- - View the machine's MAC address.
Wi-Fi Direct Push Button
- - Configure your Wi-Fi Direct network
settings using the one-button push
method.
609