• If you configure your machine using EAP-TLS authentication, you must install the client certificate
issued by a CA before you start configuration. Contact your network administrator about the client
certificate. If you have installed more than one certificate, we recommend writing down the certificate
name you want to use.
• If you verify your machine using the common name of the server certificate, we recommend writing
down the common name before you start configuration. Contact your network administrator about the
common name of the server certificate.
2. Press .
3. Press a or b to select the [Find Wi-Fi Network] option, and then press OK.
4. When [Enable WLAN?] appears, press c.
The wireless setup wizard starts. To cancel, press d.
5. The machine will search for your network and display a list of available SSIDs. Press a or b to select the
[<New SSID>] option, and then press OK.
6. Enter the SSID name, and then press OK.
For more information about how to enter text, see Related Information.
7. Select the Authentication Method, and then press OK.
8. Do one of the following:
• If you selected the [EAP-FAST], [PEAP] or [EAP-TTLS] option, select the Inner Authentication method
[NONE], [CHAP], [MS-CHAP], [MS-CHAPv2], [GTC] or [PAP], and then press OK.
Depending on your Authentication method, the Inner Authentication method selections differ.
Select the encryption type [TKIP+AES] or [AES], and then press OK.
Select the verification method [No Verification], [CA] or [CA + Server ID], and then press
OK.
- If you selected the [CA + Server ID] option, enter the server ID, user ID and password (if
required), and then press OK for each option.
- For other selections, enter the user ID and Password, and then press OK for each option.
If you have not imported a CA certificate into your machine, the machine displays [No Verification].
• If you selected the [EAP-TLS] option, select the encryption type [TKIP+AES] or [AES], and then press
OK.
The machine will display a list of available Client Certificates, and then select the certificate.
Select the verification method [No Verification], [CA] or [CA + Server ID], and then press
OK.
- If you selected the [CA + Server ID] option, enter the server ID and user ID, and then press OK
for each option.
- For other selections, enter the user ID, and then press OK.
9. The machine attempts to connect to the wireless device you have selected.
If your wireless device is connected successfully, the machine's LCD displays [Connected].
You have completed the wireless network setup. To install the drivers and software necessary to use your
machine, go to your model's Downloads page at
support.brother.com.
MFC-J4535DW
Before configuring your machine, we recommend writing down your wireless network settings. You will need
this information before you continue with the configuration.
1. Check and record the current wireless network settings.
309
To Next Page
Loading...
Need help?
General
Weight and Dimensions
