Brother MFC-J4710DW

Chapter 8
72
How to set a new default 8
You can save the Scan to Media settings
(Scan Type, Resolution, File Type,
Auto Crop, Skip Blank Page
1
and
Remove Background Color) you use
most often by setting them as the default
settings. These settings will stay until you
change them again.
1
(For MFC-J4710DW)
a Open the media slot cover.
b Put the memory card or USB Flash
memory drive in the correct slot.
c Press Scan to Media.
d Press Options.
e Swipe up or down, or press a or b to
display Scan Type, Resolution,
File Type, Auto Crop,
Skip Blank Page
1
or
Remove Background Color, and
then press the setting you want to
change. Then press the option you want
to set.
1
(For MFC-J4710DW)
Repeat this step for each setting you
want to change.
f After you are finished choosing your
preferred settings, swipe up or down, or
press a or b to display
Set New Default.
g Press Set New Default.
h The Touchscreen asks you to confirm
the change to the new default settings.
Press Yes to confirm.
i Press .
How to reset to the factory
settings 8
You can restore all the Scan to Media settings
(Scan Type, Resolution, File Type,
Auto Crop, Skip Blank Page
1
and
Remove Background Color), that you
have changed, to the factory settings.
1
(For MFC-J4710DW)
a Open the media slot cover.
b Put the memory card or USB Flash
memory drive in the correct slot.
c Press Scan to Media.
d Press Options.
e Swipe up or down, or press a or b to
display Factory Reset.
f Press Factory Reset.
g The Touchscreen asks you to confirm to
change back to the factory settings.
Press Yes to confirm.
h Press .