Before Faxing
Set Your Station ID
Set the machine to print your Station ID and
the fax's date and time at the top of each fax
you send.
1
Press
[Settings] > [All
Settings] > [Initial Setup] >
[Station ID] > [Fax].
2
Enter your fax number (up to 20 digits)
using the LCD, and then press [OK].
3
Press [Tel].
4
Enter your telephone number (up to 20
digits) using the LCD, and then press
[OK].
5
Press [Name].
6
Enter your name (up to 20 characters)
using the LCD, and then press [OK].
• Press to cycle between
letters, numbers and special
characters. (The characters available
may differ depending on your country.)
• If you enter an incorrect character,
press d or c to move the cursor to it
and press . Press the correct
character.
• To enter a space, press [Space].
• For more information, see Related
Information.
7
Press .
(USA only) The Telephone Consumer
Protection Act of 1991 makes it unlawful for
any person to use a computer or electronic
device to send any message via a telephone
fax machine unless such messages clearly
contain, in a margin at the top or bottom of
each transmitted page, or on the first page of
the transmission, the date and time it is sent
and an identification of the business or other
entity or other individual sending the message
and the telephone number of the sending
machine or such business, other entity or
individual. To program this information into
your machine, see Set the Date and Time and
Set Your Station ID.
NOTE
• How to Enter Text on Your Brother Machine
on page 60
Related Information
6
Fax
28
To Next Page
Loading...
Need help?
General
