Print on Envelopes, Thick
Paper or Labels
When the back cover (face up output tray) is
pulled down, the machine has a straight paper
path from the MP tray on the front of the
machine through the back of the machine and
onto the face up output tray. Use the MP tray
and output method for printing on thick paper
or envelopes.
• Load the paper or envelope into the MP
tray with the printing surface face up.
• DO NOT load more than 10 envelopes in
the MP tray. Doing this may cause a jam.
• DO NOT exceed the maximum paper
mark when you load paper in the MP
tray. Doing this may cause a jam.
1
Open the machine's back cover (the
face up output tray).
2
Open the paper stopper (Available only
for certain models).
3
On the front of the machine, open the
MP tray and lower it gently.
4
Pull out the MP tray support (1) and
unfold the flap (2).
5
Slide the MP tray paper guides to fit the
width of the paper that you are using. If
the paper guide on the right side has a
lever, press it and slide the paper guide.
16
To Next Page
Loading...
Need help?
General
