Load Paper in the
Multi‑purpose Tray
(MP Tray)
When you load a different size and type of
paper in the tray, you must change the
Paper Size and Paper Type settings in the
machine or on your computer, also.
When you use envelopes, thick paper, or
labels, see Related Information: Print on
Envelopes, Thick Paper or Labels.
1
Lift the support flap to prevent paper
from sliding off the face down output
tray.
2
Open the MP tray and lower it gently.
3
Pull out the MP tray support (1) and
unfold the flap (2).
4
Slide the MP tray paper guides to fit the
width of the paper you are using. If the
paper guide on the right side has a
lever, press it and slide the paper guide.
5
Load paper with the printing surface
face up in the MP tray. When you use
Letterhead or Preprinted paper, load the
paper in the correct orientation as
shown in the illustrations.
10
To Next Page
Loading...
Need help?
General
